Hendi 2000 Bedienungsanleitung Seite 6

Suitable cooking equipment
Bottom of cookware
Material
Diameter of the bottom
Type of cookware
Note: Using a pan or pot that's not suitable for induction cooking may damage the appliance.
Operating the appliance
• Put the plug in the socket
• Set the pan of your choice on the cooking surface, bearing the above mentioned instructions in mind.
Note! Do not leave your pan on the appliance while empty as this may lead to damage to your pan.
• Switch the appliance on by pressing the "ON/OFF key"
to activate the appliance.
If your pan is suitable for induction and has a bottom diameter of 12cm, at minimum, the appliance will go
EN
into operation.
If you have pressed the power key
recognize this from the fact that the fan will go on and the display will show a capacity position of "100".
On the other hand, if you have pressed temperature key
operation, the default temperature is 100ºC.
Note! If the appliance beeps after being switched on, the pan you are using is not suitable for induction or
the appliance is defective. In case of any doubt, always contact the supplier of your pan!
Once the appliance is operating, it enters the Capacity mode by default, and the display indicates position
"100", you can programme the appliance in one of the following ways.
• Capacity mode: You can control the performance of the appliance, just as for a gas cooker via 11 positions
ranging from 100W to 2000W.
• Temperature mode: you can set the temperature between 35ºC and 240ºC in 5ºC increments. Standard
position for the appliance is 100ºC.
NOTE: if we keep pressing the arrow keys, the SET temperature increases in a fast speed.
Attention! The programmed temperature is that of the glass plate and not the temperature in the pan!
6
Suitable
Flat bottom
Cookware with iron, cast iron, magnetic stain-
less steel or enamelled iron bottom.
Between 12 cm and the maximum diameter
marked on the induction surface.
Cookware with a bottom thickness over 1.5 mm.
, the appliance will enter in capacity mode operation and you will
Not suitable
Curved, uneven, rounded bottom
Cookware with ceramic, glass, copper,
bronze, or aluminium bottom.
Less than 12 cm or more than the
maximum diameter marked on the
induction surface.
Completely closed containers or cans.
and either the temperature key
, the appliance will enter in temperature mode
or power key