Bosch FWA 9000 Originalbetriebsanleitung Seite 20

en | 20 | FWA 9000 | Product description
3.3.2 Important notes on operation
!
Check the sensor heads for condensation before
switching on.
¶
In the event of moisture, wait for the moisture on
the measuring system to evaporate.
!
Do not place any objects on the protective laser
housing.
3.3.3 Fitting and transportation
!
Pick up the sensor heads only by way of the unit
handle.
!
Transport with care.
¶
Avoid impact on the sensor heads.
¶
Take care not to drop the sensors.
3.3.4 Sensor head position
!
The sensor must be screwed to the adapter plate.
!
The sensor head is to be moved in longitudinal and
transverse direction only by way of the unit handle.
1
3
Abb. 5: Measurement bay sensor head position
1 Front left sensor head
2 Front right sensor head
3 Rear left sensor head
4 Rear right sensor head
|
1 690 906 002 2017-07-04
3.3.5 Connection
i
The sensor head cables must be connected:
Sensor
Front left
Front right
Rear left
Rear right
i
The sensor heads must be switched on.
3.3.6 Status LED:
Status
Switch on sensor heads
Establishing
sensor <-> trolley link
Wheel alignment unit ready
i
The PC/laptop in the trolley must be on and the
wheel alignment program started.
3.4 Control cabinet
4
1
1 Master switch
2 Malfunction indicator light
i
Operation:
1. Switch on electrical cabinet.
2. Start the PC/laptop.
i
After use:
3. Shut down PC in the equipment trolley.
4. Switch off the electrical cabinet.
!
The electrical cabinet must be turned off when it is
not in use.
!
The ground fault interrupter (GFI) must be checked
every 6 months. The check must be performed by an
electrically qualified person.
Voltage Data Turntable
X X x
X X x
X X –
X X –
Color Behavior
Orange Lit
Orange <-> Flashing
Green
Green Lit
2
Robert Bosch GmbH