User-Code - Assa Abloy ANYKEY - Türcode Bedienungsanleitung

2 . 4 U s e r - C o d e
Notice
Please heed the notes concerning codes in chapter „Codes general"
The User-Code gives authorisation to open the door.
The fitting is been activated/deactivated with a correct User-Code.
The storage locations 1 to 39 are for the User-Codes.
The User-Codes at storage locations 1 to 9 have always the authorisation to switch on/off the permanent
release.
The User-Codes at storage locations 10 to 39 can get the authorisation to switch on/off the permanent release.
Every code has to be unique.
The User-Code must have at least 3 digits.
Short User-Codes cannot have the same number sequence as longer User-Codes.
2.4.1 Creating a user 1 (storage location 1 to 9 and 10 to 39)
The User-Codes at storage locations 1 to 9 gets as well the authorisation of temporary release as the authorisation
of permanent release.
The User-Codes at storage locations 10 to 39 only gets the authorisation for temporary release. How to assign the
authorisation for permanent release, see chapter "Create a user 2".
Press keys
The programmed User-Code can now be used.
Notice
If there is another flash sequence shown as described, the progamming failed. The User-Code cannot be
used. Get to know the described procedure and program the User-Code another time.
D00471
04
Signalling Function
Start the programming
Enter Master-Code and acknowledge
(3 to 8 digits).
Enter storage location (1 to 9) and acknowledge
(storage location).
Enter new User-Code and acknowledge
(3 to 8 digits).
2 x
The programming was successful.
Programming instructions
Page 45