Master-Code - Assa Abloy ANYKEY - Türcode Bedienungsanleitung

2 . 3 M a s t e r - C o d e
The Master-Code is intended to provide support during installation.
The Master-Code is 0 (zero) by the initial installation.
This is valid till a new Master-Code will be programmed.
The Master-Code can have 3 to 8 digits.
With the Master-Code you can activate and deactivate the security fitting during initial installation.
Beware
Access of unauthorised persons is possible! There is a security leak!
Program the Master-Code at once.
If you leave the fitting in the original installation mode, it can be activated with pressing 0 (zero).
2.3.1 Programming Master-Code after the installation
Press keys
The new Master-Code is now active. Use this new Master-Code for all further programming procedures.
Notice
If there is another flash sequence shown as described, the progamming failed. The old Master-Code
remains active. Get to know the described procedure and program the Master-Code another time.
D00471
04
Signalling Function
Start the programming
Press 0 and acknowledge
(Master-Code after initial installation).
Press 0 and acknowledge (storage location).
Enter new Master-Code and acknowledge
(3 to 8 digits).
Continue programming
Press 0 and acknowledge
(Master-Code after initial installation).
Press 0 and acknowledge (storage location).
.
Enter new Master-Code and acknowledge
(3 to 8 digits).
.
.
2 x
The programming was successful.
Programming instructions
Page 43