86
VOLTIMA VSI/VST Series
Attention!
In order to protect against cable fires, it is mandatory to install a fuse between the inverter
and the battey in the PLUS line!
Install the fuse as close to the battery side as possible.
Note!
Sparking!
When connecting the input DC voltage source, sparking occurs due to the charging of the
internal capacitors.
Grounding
The Voltima inverter has an M5 earth bolt. This is used to connect the inverter to the vehicle
ground when used in vehicles.
The grounding of the two output sockets (230V) are already internally connected to the M5
grounding bolt.
Fault current circuit breaker (RCD circuit breaker)
The Voltima inverter is equipped with an internal fault current circuit breaker (RCD).
Note!
The grid feed into the vehicle must also be equipped with an RCD circuit breaker according to
standardization!