VOLTIMA VSI-Serie Montage- Und Bedienungsanleitung Seite 68

68 VOLTIMA VSI/VST Serie
•
The devices may only be installed in dry and dust-free rooms. The Voltima inverters
must be kept away from aggressive battery gases.
•
There are no parts of the
Never open the
•
Disconnect the connection (DC) to the battery before installing or dismantling the
Voltima inverter.
•
Install the line fuses as required by the user manual.
•
Make sure that the line connections have appropriately fixed seat to avoid heating
by local connections.
•
The device must never be installed in places where there is a risk of gas or dust
explosion!
•
Never operate the device outdoors.
•
Never connect external voltage (mains voltage) or a generator or other inverter to
the sockets of the Voltima inverter, as this will destroy the unit.
•
Never install 12V cables and 230V lines in a common conduit or cable duct.
•
All voltage-carrying cables must be regularly checked for insulation faults,
breakpoints, as well as for loose connections.
Defects found must be rectified immediately.
•
When working on the electrical system and during welding work, the device must
be disconnected from all connections.
•
Compliance with the building and safety regulations of any kind is subject to the
user or buyer.
•
Follow the recommendations and safety regulations of the battery manufacturer.
•
The device must not be opened under any circumstances. It does not contain any
parts that need to be replaced by the user. Please note that dangerous voltages are
present after disconnecting the device from the battery for a long time.
•
Keep children away from batteries and inverters.
•
In the event of improper use of the device, when operating outside the technical
specification, as well as in case of improper operation or third-party intervention,
the warranty expires. No liability is assumed by the manufacturer for the resulting
damages.
inverter that need to be serviced or repaired by the user.
Voltima inverter or carry out appropriate repairs.