VOLTIMA VSI-Serie Montage- Und Bedienungsanleitung Seite 84

84 VOLTIMA VSI/VST Series
Assembly instructions
The Voltima inverter should be mounted near the battery(s). The supplied battery cables have
a length of approx. 95cm.
The installation location should be clean and dry. To ensure optimum cooling of the unit, care
should be taken not to cover the air outlet openings and the fans.
A minimum distance of 25 cm must be maintained around the device, as well as to the air
outlet openings and to the fans. If the inverter is installed in a storage space, it must have a
sufficient ventilation volume to ensure a good air exchange with the ambient air. Installation
should be carried out on a flat, hard and non-combustible mounting surface. Additional
rubber elements can be used to reduce vibration.
Attention!
Make sure the inverter is turned OFF before connecting to the battery.
Attention!
•
Reverse polarity will blow the fuse or damage the inverter. Damage caused by incorrect
connection is not covered by the warranty.
•
The inverter may only be connected to batteries with a normal output voltage of 12V or
24V.
•
Provide adequate ventilation when using batteries.
Batteries can produce flammable gases during charging or discharging.
•
Sparks may be generated when the inverter is connected to the battery, so make sure
there are no flammable vapours before making the connections.
Attention!
We recommend not to use consumers whose power is more than 90% of the rated power of
the inverter.