VOLTIMA VSI-Serie Montage- Und Bedienungsanleitung Seite 85

Installation
The Voltima inverter is supplied at the factory with a 95cm long battery cable.
1. The red cable (+) is connected to the plus pole (red marking) of the inverter.
2. The other free end is then connected to the battery (plus pole) via a fuse (see
picture p.87).
3. The fuse should be placed as close as possible to the battery side.
4. The black cable (-) is connected to the negative pole (black marking) of the inverter.
The other free end is connected to the battery (minus pole).
5. Make sure that the ON/OFF switch of the device is set to "OFF".
6. After connecting the two battery cables to the DC connectors of the inverter, the
two covers (red & black) must be attached.
7. Insert the red cover over the open red cable end and fasten it to the unit with the
enclosed screws. Also insert the black cover over the black negative cable and
fasten it to the unit with the enclosed screws.
25cm
VOLTIMA VSI/VST Series 85