B. Braun Aesculap ElanEC GA835 Serviceanleitung Seite 21

ELANEC GA830 / GA835
Legend
1 Flexible shaft connection
2 Flexible shaft sensor
3 LED "CCW operation"
4 LED "CW operation"
5 "Mains Off" - Switch
6 "Mains On" - Switch
7 LED "Mains On"
8 LED "Pump On" (GA835 only)
9 Flow rate control (GA835 only)
10 Lever (GA835 only)
11 Coolant pump (GA835 only)
12 Connection for sterile fluid bottle support bracket
(GA835 only)
13 Support bracket for sterile fluid bottle (GA835 only)
14 Control cable socket
15 Ventilation grille
16 Equipotential socket
17 Fuse holder including voltage selection insert
18 Power plug socket
19 Flexible shaft support connection
A Motherboard GA835810
B Pump control card GA835801
C Display board GA835820
D Filter board GA835802
E Motor
F Fan
G End shield
ã ã ã ã
Copyright 2001
Aesculap AG & CO KG
All rights reserved
June 2001
The information contained in this service manual is
protected by copyright laws. All rights are protected.
The information contained in this service manual may
not be copied or otherwise reproduced either in whole
or in part without the express permission of Aesculap
AG & CO. KG.
The technical information,
dimensions in this manual should not be construed as
a commitment by Aesculap. No claims may be made
on the basis of the information contained herein. We
reserve the right to make improvements without
altering this documentation.
We reserve the right to make technical changes without
prior notice.!
Ø For service, maintenance and repairs, contact the
AESCULAP/B. Braun representative in your country.
Ø All guarantees and warranty rights as well as
licenses will be voided if modifications on the unit
are performed.
Service address:
AESCULAP Technischer Service
Am Aesculap-Platz
D-78532 Tuttlingen
Germany
Tel.: +49 (7461) 95 27 00
Fax: +49 (7461) 16 28 87
E-Mail: ats@aesculap.de
Other service addresses can be obtained from the address
indicated above.
GB
   
illustrations and
18