Led Display; Communication Interfaces - Dräger Polytron 6100 EC WL Gebrauchsanweisung

4.1

LED display

Symbol LED display Meaning
Green LED Gas detector is switched on
flashes once
Yellow LED Alerts (e.g., low battery or sensor warm-up
flashes once phase active) or maintenance mode
Yellow LED lights Error
up continuously
Red LED (gas A1 alarm (pre-alarm)
detector only) rap-
idly flashes once
Red LED (gas A2 alarm (main alarm)
detector only) rap-
idly flashes twice
Blue LED flashes
Bluetooth
once
Blue LED lights up
Bluetooth
continuously
mobile device
Yellow and blue Confirmation, internal battery counter reset
LEDs light up
Instructions for use |
Dräger Polytron
®
active
® ®
active, connected to Windows
®
6100 EC WL, Dräger Polytron
4.2

Communication interfaces

®
4.2.1 Bluetooth interface
After the start sequence, the Bluetooth
activated.
If no connection is established, the gas detector disables the interface after 10
minutes (factory setting).
If the connection is to be secured with a pairing PIN, an additional pairing can
be carried out and an individual pairing PIN assigned. The factory setting is the
connection without PIN.
For safety-related applications, an individual pairing PIN must be assigned.
4.2.2 Activating the Bluetooth
®
● Activate the Bluetooth interface with a magnetic pen or via the
™
ISA100 Wireless network:
● Magnetic pen: Tap the marking (Fig. A 12).
™
● ISA100 Wireless : Activate using PolySoft.
✓ The blue LED flashes.
4.2.3 Performing Bluetooth
the first time
®
The first time a Bluetooth connection is established, a pairing must be made
between the gas detector and the Windows
exchange characteristic data, meaning that they automatically recognize each
other the next time they are connected.
Prerequisite:
®
– Bluetooth interface on the gas detector and on the Windows
is activated.
®
– Bluetooth pairing is activated (with PolySoft).
®
● If the Bluetooth pairing PIN "000000" is used, Bluetooth
automatic.
®
Repeater ISA
Operation
®
interface of the gas detector is
®
interface
®
pairing and connecting for
®
end device, i.e. both devices
®
end device
®
pairing is
| en
37