Input Selection And Av Connections; Input Signal Selection - Toshiba REGZA XF355 Serie Bedienungsanleitung

Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page
7 for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal through
the SCART lead to switch the television to the correct Input
socket.
Alternatively press the external source selection button
until the picture from connected equipment is shown.
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT3C).
o
An S in the display e.g. 2S (EXT 2S), indicates the input
is set for an S-Video signal.
Input selection
a
At any time by pressing
screen showing modes and all stored external
B
equipment. Use and
select.
DTV
1
2
3C
HDMI1
HDMI2
HDMI3
PC
ATV
NOTE: When in digital mode ATV cannot be
selected, in analogue mode DTV cannot be
selected. To switch between DTV and ATV press
the A/D button.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input RGB/PC
on the back of the television.
Input selection and
AV connections
o
o
a list will appear on
b
to highlight and OK to

INPUT signal selection

This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
a
In the SET UP menu press
is highlighted, then press OK.
Language
Country
Auto tuning
Manual tuning
Antenna Amplifier
AV connection
Back
MENU
b
C
With or
required input for EXT2.
PC/HDMI1 audio
HDMI1 audio
HDMI setting
EXT1 output
EXT2 input
EXT2 output
Back
MENU
If the colour is missing try the alternative setting.
36
b
until AV connection
SET UP
English
UK
OK
OK
On
OK
Watch TV
EXIT
c
select either AV or S-VIDEO as the
AV connection
PC
Digital
DTV
AV
DTV
Watch TV
EXIT
1/2