Input Signal Selection; Input Selection And Av Connections - Input And Output Sockets For Connected Equipment - Toshiba 46WM48-Serie Bedienungsanleitung

Input selection and AV connections
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most VCRs and decoders send a signal through the
SCART lead to switch the television to the correct Input
socket. Alternatively press the external source selection
B
button until the picture from connected equipment is
shown. This button must be used to view equipment
connected using the COMPONENT VIDEO INPUT (EXT4).
An S in the display e.g. 3S (EXT 3S), indicates the
B
input is set for an S-Video signal.
Input selection
Use the Input Selection if the television does not switch
over automatically.
Press B to select B
1
(EXT1-5), HDMI or PC.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
To return to television mode press
2
one of the numbered buttons.
To bring up the EXT menu, press and hold

INPUT signal selection

This specifies the type of signal going into SCART 3 (EXT3)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press Q until
1
AV connection is highlighted, then press OK.
With S or R select either AV or S-VIDEO as the
required input for EXT3.
1, 2, 3, 4C, 5
B B B B
again or
B
.
B
If the colour is missing try the alternative setting.
EXT3 input
EXT3 output
Woofer
Audio output
MENU Back EXIT
OUTPUT signal selection for SCART 3
This enables selection of the source to output from
SCART 3. For example, to record transmissions in stereo
from a stereo decoder – connect a stereo decoder to
SCART 1 and stereo VCR to SCART 3, then select EXT1 as
the EXT3 output. The signal received through SCART 1
will output directly through SCART 3.
Select AV connection.
1
EXT3 input
EXT3 output
Woofer
Audio output
MENU Back
Use S or R to change the EXT3 output option to:
2
TV = The last television programme selection.
Monitor = The picture on screen.
EXT1 = The picture from equipment connected
to SCART 1.
EXT2 = The picture from equipment connected
to SCART 2.
EXT5 = The picture from equipment connected to
the side input sockets.
HDMI, the HDMI logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC.
19
AV connection
EXT1
External
Fixed
Watch TV
AV connection
EXT1
External
Fixed
EXIT Watch TV
AV
AV