Input Signal Selection; Input Selection And Av Connections - Input And Output Sockets For Connected Equipment - Toshiba 26/32WL36 Bedienungsanleitung

Input selection and AV connections
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most VCRs and decoders send a signal through the Scart
lead to switch the TV to the correct Input socket.
Alternatively press the external source selection button
B until the picture from connected equipment is shown.
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT1 and EXT2).
An S e.g. 3S (EXT 3S), indicates the input is set for an
B
S-Video signal.
Use the Input Selection if the TV does not switch over
Press B
1
6 (EXT1-6) or PC.
B
PC displays a computer connected to Input
RGB/PC on the side of the TV.
To return to TV mode press
2
the numbered buttons.

INPUT signal selection

This specifies the type of signal going into Scart 3 (EXT3)
on the back of the TV. Please refer to the manufacturers
instructions for the connected equipment.
In the SET UP menu press Q until
1
AV connection is highlighted, then press OK.
With S or R select either AV or S-VIDEO as the
required input for EXT3.
If the colour is missing try the alternative setting.
EXT3 input
EXT3 output
Woofer
Audio output
MENU Back
Downloaded from www.Manualslib.com
Input selection
automatically.
1, 2, 3, 4,
to select B B B B
again or one of
B
AV connection
AV
EXT1
Ext.
Fixed
EXIT Watch TV
manuals search engine
OUTPUT signal selection for Scart 3
This enables selection of the source to output from
Scart 3. For example, to record transmissions in stereo
from a stereo decoder – connect a stereo decoder to
Scart 4 or 5 and stereo VCR to Scart 3, then select EXT4
or EXT5 as the EXT3 output. The signal received through
Scart 4 or 5 will output directly through Scart 3.
1
EXT3 input
EXT3 output
Woofer
5,
B
Audio output
MENU
2
18
Select AV connection.
AV connection
Back EXIT Watch TV
Use S or R to change the EXT3 output option to:
MONITOR = The picture on screen.
TV = The last television programme selection.
EXT1 = The picture from equipment connected
to 1.
B
EXT2 = The picture from equipment connected
to B 2.
EXT4 = The picture from equipment connected to
Scart 4.
EXT5 = The picture from equipment connected to
Scart 5.
EXT6 = The picture from equipment connected to
the front input sockets.
AV
EXT1
Ext.
Fixed