Input Selection And Av Connections; Input Selection; Input Signal Selection - Toshiba AV50 Series Handbuch

00GB_AV505D_EngOM.book Page 31 Saturday, November 24, 2007 5:53 PM
Input selection and AV
connections
Defining the INPUT and OUTPUT sockets so that
the television recognises connected equipment.
See page 7 for a clear view of the back connection
recommendations.
Most media recorders and decoders send a signal through the
SCART lead to switch the television to the correct Input socket.
Alternatively press the external source selection button
until the picture from connected equipment is shown.
This button must be used to view equipment connected using
the COMPONENT VIDEO INPUT (EXT3) and the VIDEO INPUT
(EXT4).
o
An S in the display e.g. 2S (EXT 2S), indicates the input is set
for an S-Video signal.

Input selection

Use the Input Selection if the television does not switch over
automatically.
a
o
At any time by pressing
showing all stored programmes and external
U u
equipment. Use and
select.
DTV
1
2S
3
4
HDMI1
HDMI2
ATV
HDMI™ displays equipment connected to Input HDMI
on the back of the television. It is designed for best
performance with 1080i high definition signals.
a
o
b
a list will appear on screen
Q
to highlight and to
31
CONTROLS AND FEATURES

INPUT signal selection

This specifies the type of signal going into SCART 2 (EXT2) on
the back of the television. Please refer to the manufacturers
instructions for the connected equipment.
In the SET UP menu press
Q
highlighted, then press
SET UP
Language
Country
Auto tuning
Manual tuning
AV connection
Picture position
MENU Back EXIT Watch TV
I i
With or select either AV or S-VIDEO as the
required input for EXT2.
AV connection
HDMI1 audio
Lip Sync
EXT2 input
Back Watch TV
MENU EXIT
If the colour is missing try the alternative setting.
u
until AV connection is
.
1/2
English
UK
OK
OK
OK
OK
Digital
AV