Manual Setting - Toshiba REGZA XF355 Serie Bedienungsanleitung

Below are the answers to some of the most common queries.
For more information go to www.toshiba.co.uk
Q
Why is there no sound or picture?
A
Check the television is not in standby mode. Check
the mains plug and all mains connections.
Q
There is a picture, but why is there little or no
colour?
A
When using an external source, for instance, a
poor quality video tape, if there is little or no
colour, improvements may sometimes be
achieved. The colour is factory set to Auto. to
automatically display the best colour system.
To check that you have the best colour:
a
With the external source playing, select Manual
setting from the SET UP menu.

Manual setting

Colour system: Auto.
EXT2 A
Store
OK
Back
MENU EXIT
b
B b
With or choose between Auto., PAL, SECAM,
NTSC 4. 43 or 3. 58.
Q
Why doesn't the video/DVD being played show
on screen?
A
Make sure the VCR or DVD player is connected to
the television as shown on page 7, then select the
correct input by pressing
Q
Why is there a good video picture but no
sound?
A
Check all lead connections.
Q
Why is there a picture but no sound?
A
Check the volume has not been turned down or
that sound mute has not been selected.
Questions and
V C R
Watch TV
o
.
Answers
Q
Why is the VCR/DVD picture in black and
white?
A
Check the correct input has been chosen,
S-VIDEO or AV. See AV connections page 36.
Q
Why is there picture and sound interference on
all digital and analogue channels?
A
The signal strength may be too strong. Set the
Antenna Amplifier option in the SET UP menu to
Off.
Q
What else can cause a poor analogue picture?
A
Interference or a weak signal. Try a different
television station. Manual fine tuning may help.
a
Select the Manual tuning menu. Highlight the
station and press OK, then press
Manual fine tuning.
b
B
Using or
sound. Press OK and then EXIT.
1 I
OK Store
Back
MENU
Q
Why don't the controls on the front of the
television work?
A
Check that Panel lock is not ON.
Q
Why doesn't the remote control work?
A
Check the side switch on the remote control is in TV
mode.
Check the batteries aren't dead or inserted
incorrectly.
Q
Why is there a message permanently on the
screen?
A
Remove it by pressing
43
c
to select
b
adjust to get the best picture and
Manual tuning
Manual fine tuning
A C 22 +2 B B C 1
Watch TV
EXIT
.