Possible Cause - Homelite F-2035 Bedienungsanleitung

F2035 _17 lgs 5/12/03
GB
F D E
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start.
Engine starts but will not
accelerate.
Engine starts but will only run
at high speed at half choke.
Engine does not reach full speed
and emits excessive smoke.
Engine starts, runs, and
accelerates but will not idle.
11:28 Page 16
I P NL S DK
English

POSSIBLE CAUSE

1. No spark.
2. No fuel.
3. Flooded engine.
4. Starter rope pulls harder
now than when new.
Carburetor requires
adjustment
Carburetor requires
adjustment
1. Check oil fuel mixture.
2. Air filter dirty.
3. Carburetor requires
adjustment.
Carburetor requires
adjustement
16
N FIN GR H CZ
SOLUTION
1. Check spark. Remove sparking plug. Reattach the
sparking plug cap and lay sparking plug on metal
cylinder. Pull the starter rope and watch for spark at
sparking plug tip. If there is no spark,
repeat test with new sparking plug.
2. Push primer bulb until bulb is full of fuel. If bulb does
not fill, primary fuel delivery system is blocked.
Contact a service dealer. If primer bulb fills, engine
may be flooded (see next item).
3. Remove spark plug, turn trimmer so spark plug hole
is aimed at the ground.
Move choke lever to "RUN" and pull starter cord 10 to
15 times. This will clear excess fuel from engine.
Clean and reinstall sparking plug. With the throttle
trigger fully depressed, pull starter cord three times
with lever at "RUN" position. If engine does not start,
move choke lever to "CHOKE" and repeat normal
starting instructions. If engine still fails to start,
repeat procedure with a new sparking plug.
4. Contact a service dealer.
Turn "L" needle counterclockwise 1/16 turn. If "L" low
needle (44) can not be turned counterclockwise, do not
force plastic limiter caps. Contact a service dealer (Fig. 22).
Turn "H" needle counterclockwise 1/16 turn. If "H" high
needle (45) can not be turned counterclockwise, do not
force plastic limiter caps. Contact a service dealer (Fig. 22).
1. Use fresh fuel and the correct 2-cycle oil mix.
2. Clean air filter. Refer to "Replacing and Cleaning
Air Filter" earlier in this manual.
3. Turn "H" needle clockwise 1/16 - 1/8 turn (Fig. 22).
Turn idle speed screw (43) clockwise to increase idle
accelerates but will not idle speed (Fig.22).
RUS RO PL