Casualplay Beat S Anwendungshinweise Seite 16

Recline (see illustration 4c)
• The AUTOPLAY seat can easily change position from upright to recline with only one hand by
using the adjustment handle at the front of the seat.
NOTE: Check that seat is not between two positions.A "click" sound will confirm that child
seat is locked in the right position.
fastening buckle according to the model (see illustrations 5c - 6c)
• To close the harness buckle, check shoulder straps are not twisted , joint the two parts and
introduce them into the female part with red button and push until to hear a "click" sound. To
open push the red button.
Removing the harness (diagrams A - f)
• Loosen the harness by pressing the rear part of the TMS downwards and pulling the chest straps
underneath the protectors with the other hand (fig.A).
• Take the two ends of the harness out of the distribution bar (fig.B), situated on the lower part of
the frame. Then pass the harness through the slots on the frame and the headrest.
• Take the plastic clips off the chest protectors (fig.C), on the back of the frame, and pass the straps
through the slots (fig.D).
• Remove the protectors (fig.E).
• Pass the strap through the flap in the buckle (fig.F)
• Conceal the buckle under the upholstery.
• Remove the elastic strips that fasten the upholstery onto the frame and the abdominal protectors.
These strips are situated on the sides on the lower part of the frame. Take the protectors of the
strap (according to model).
• Lift the upholstery up, find the clips and pass the strap through the slots. The clips are on both
sides of the lower part of the frame.
• Follow the steps in reverse order to fit the harness, taking care that the straps are not twisted
(fig.G). The inner plastic strip of the abdominal protectors should stay on the inside, first fasten the
elastic bands of the protector and then those of the upholstery.
Removing the upholstery (According to model. See diagrams H - J)
• Remove the harness following the instructions in the corresponding section.
• Remove the headrest. Undo the nut on the back of the headrest (fig.H), then use the height
adjustment handle to raise the headrest until it comes off (fig.I). Remove it.
• Take the elastic strips off that hold the upholstery to the frame. These strips are situated on the
sides of the lower part of the frame.
• Pass the harness straps through the openings in the upholstery and take the upholstery off
(fig.J).
• Follow the same steps in reverse order to fit the upholstery.
Removing the upholstery (According to model. See diagram K)
• Loosen the harness by pressing the rear part of the TMS downwards and pulling the chest straps
underneath the protectors with the other hand.
• Release the clasps on the backrest (fig.K).
• Release the elastic bands on both sides situated underneath the frame.
• Remove the upholstery.
• Follow the same steps in reverse order to fit the upholstery.
NOTE: Never take out the interior protection in the absorbent material.
Washing instructions
• Machine wash the cover at a maximum temperature of 30ºC and without spinning. The painted
parts should be cleaned using a non-abrasive polish that does not contain solvents.
14