Inhaltsverzeichnis
Werbung
Appendix III: Standardeinstellungen (CM5 mit Anybus-Modul)
Die Werkseinstellungen des CM5 mit Anybus-Modul sind wie folgt festgelegt:
Operating mode:
Control mode:
Voltage setpoint:
Current limit:
Lock mode:
User password:
Bus address:
User voltage limit:
User current limit:
Remote HV on/off source (Lokaler Modus):
Remote HV on/off source (Fernbedienungsmodus): Continuous
Remote HV on/off source (Feldbus-Modus):
Remote limit control:
Advanced output control:
Advanced output control:
Setpoint voltage start:
Setpoint voltage max:
High level:
Trigger level:
Readout stretched:
Limited LED stretched:
Display readout:
Backlight:
Contrast:
Remote I/O mode OutU:
Remote I/O mode OutI:
Remote I/O mode SetU:
Remote I/O mode SetI:
Remote I/O mode AdvOutC:
Remote I/O mode BarCont:
Pin9 output mode:
CM5_UM_9752090113_D_V1_5
Fieldbus
VC (=Voltage Control)
0,0 kV
2,5 mA (oder 5,0 mA)
Unlocked
Unverändert
126
60,0 kV (oder 30,0 +kV)
2,5 mA (oder 5,0 mA)
Continuous
Bus
Local controlled
Continuous
5,0 kV
15,0 kV
80%
10%
0,7 sec.
0,7 sec.
kV & mA
85%
50%
0 – 5V DC
0 – 5V DC
0 – 5V DC
0 – 5V DC
0 – 5V DC
0 – 5V DC
Limit alarm
65
Werbung
Inhaltsverzeichnis
