Technical Specifications - TermaTech TT20 Serie Montage- Und Bedienungsanleitung

The stove is difficult to light and may die out
There may be a number of causes. The most typical are:
• The damper is not sufficiently open.
• The firewood is too wet.
•
The draught in the chimney is too small or maybe it is blocked or leaking.
•
The ember layer was too small/incinerated and did not give enough heat to light the logs.
Possibly give some start-up air to the fire by opening the damper (pushed down and to the
right) to get the stove going again. Then the damper has to be closed again (back to position
between left and the middle).
Depending on the problem it may be necessary to contact the dealer, installer or a chimney
sweep.
The glass soots up
The wood is too moist.
Lack of draught in the chimney.
Check that the damper is not closed.
Door is closed too early at lighting (point 3 section 2).

TECHNICAL SPECIFICATIONS

Nominal heat output:
Height:
Width:
Depth:
Weight ca.:
Nominal heat output:
Height:
Width:
Depth:
Weight ca.:
Nominal heat output:
Height:
Width:
Depth:
Weight ca.:
Average values for testing of TT20/21 models:
Exhaust gas temperature 273 °C
Exhaust gas mass flow
Efficiency
Nominal Heat output
Flue draught
TT20 TT20R
5 kW 5 kW
1045mm 1045mm
478mm 531mm
419mm 419mm
117kg 118kg
TT20S+SA TT20RS
5 kW 5 kW
1075mm 1075mm
470mm 531mm
419mm 419mm
155/140kg 174kg
TT21RL TT21RLS
5 kW 5 kW
993mm 995mm
519mm 531mm
412mm 419mm
119kg 170kg
4.0 g/s
83,4%
5 kW
12 Pa
TT20Streaml. TT20Streaml. R
5 kW 5 kW
954mm 956mm
478mm 531mm
419mm 419mm
102kg 110kg
TT21R TT21RS
5 kW 5 kW
1073mm 1075mm
519mm 531mm
412mm 419mm
120kg 174kg
TT21RH TT21RHS
5 kW 5 kW
1170mm 1172mm
519mm 531mm
412mm 419mm
129kg 185kg
31