STIEBEL ELTRON DHF 13 C Bedienung Und Installation Seite 24

INSTALLATION
Installation
f Mark out the drill holes with the installation template (in the f
centre section of these instructions). If the appliance is to be
installed with water connections on finished walls, also mark
out a fixing hole in the lower part of the template.
f Drill the holes and secure the wall mounting bracket with f
2 screws and 2 rawl plugs. The screws and rawl plugs are
not part of the standard delivery.
f Mount the wall mounting bracket. f
f Mount the appliance on the threaded stud. f
f Push the back panel firmly against the wall. Secure the back f
panel using the threaded bush. You can compensate for a tile
offset with the nut on the threaded stud.
Installation with offset tiles
≤12
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
f Adjust the wall clearance with the nut on the threaded stud. f
Push the back panel firmly against the wall. Secure the back
panel using the threaded stud.
Making the water connection
Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
f Seal and insert the twin connectors. f
24 |DHF-C
3
3
2
1
1 Cold water with 3-way ball shut-off valve
2 DHW with tee
3 Gasket
f Fit the water connections. f
1
2
1 Strainer
2 Plastic profile washer
f Fit the supplied strainer in the 3-way ball shut-off valve. f
Material losses
!
The strainer must be fitted for the appliance to function.
f When replacing an appliance, check whether the f
strainer is installed (see chapter "Installation / Main-
tenance").
Fitting the cable grommet
1
1 Cable grommet
f Fit the cable grommet. f
www.stiebel-eltron.com