Mounting Of Cutter Blade Or Nylon Cutting Head - Dolmar MS-252 Originalbetriebsanleitung

MOUNTING OF CUTTER BLADE OR NYLON CUTTING HEAD

Turn the machine upside down, and you can replace the cutter blade or the nylon
cutting head easily.
– Insert the hex wrench through the hole in the gear case and rotate the receiver
washer (3) until it is locked with the hex wrench.
– Loosen the nut (1) (left-hand thread) with the socket wrench and remove the nut
(1), and clamp washer (2).
With the hex wrench still in place.
– Mount the cutter blade onto the shaft so that the guide of the receiver washer (3)
fits in the arbor hole in the cutter blade. Install the clamp washer (2) and secure
the cutter blade with the nut (1).
[Tightening torque: 13 -­ 23 N-­m]
NOTE: Always wear gloves when handling the cutter blade.
NOTE: The cutter blade-­fastening nut (with spring washer) is a consumable part. If
there appears any wear or deformation on the spring washer, replace the
nut.
NOTE: The clamp washer (2), and nut (1) are not necessary for mounting the nylon
cutting head. The nylon head should go on top of the receiver washer (3).
– Screw the nylon cutting head onto the shaft.
– Make sure that the blade is the left way up.
Loosen
Loosen
Rotation
12
Tighten
Hex wrench
Tighten
Hex wrench