Mounting Of Protector - Dolmar Ms-252 Originalbetriebsanleitung

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/ protector combinations as
indicated in the table must be used.
Be sure to use genuine DOLMAR cutter blades or nylon cutting head.
– The cutter blade must be well polished, free of cracks or breakage. If the cutter
blade hits against a stone during operation, stop the engine and check the blade
immediately.
– Polish or replace the cutter blade every three hours of operation.
– If the nylon cutting head hits against a stone during operation, stop the engine
and check the nylon cutting head immediately.
Star Blade
CAUTION : The appropriate protector must always be installed, for your own safety
and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard being in place is not
permitted.
– Fix the protector (1) to the clamp (3) with two bolts M6 x 30 (2).
– When using the string head, fit the protector (6) into the protector (1), and tighten
them with two nuts (5) and two screws (4).
Eddy Blade Protector for metal blades Nylon cutting head
11
Protector for cord cutter