Setting The Timer; Troubleshooting - Klarstein 10012195 Bedienungsanleitung

All manuals and user guides at all-guides.com
When the power level is set
1. Press the wMenuw button the third time, the power level indicator will light up and the timer control; the
display will show w0:00w.
2. Using the control button set the required time in the range of 0:01 - 3:00. The setting advances by 1 minute.
3. After setting the timer wait, until the display shows the preset power setting 1600 W. Then using the control
button set the required power level.
When the temperature is set
1. Press the „Menu" button the fourth time, the temperature level indicator will light up and the timer control:
the display will show w0:00w.
2. Using the control button set the required time in the range of 0:01 - 3:00. The setting advances by 1 minute.
3. After setting the timer wait, until the display shows the preset temperature 240 CC. Then, using control
button, set the required temperature.
Before use, make sure that the pot you would use is made of magentisable conductive material (enamel, cast iron,
stainless steel) while the bottom of the pot is flat and even and has at least 12 cm diameter. Never place empty pots/
pans on the ceramic glass cootop. Place the pot/pan always at the center of the induction zone, otherwise the lower
part of the pan is heated unevenly and the food in the pan may burn. Unsuitable cookware: ceramic, glass, alumi-
num, pots/pans with rounded/convex bottoms or with diameter less than 12 cm or larger than 30 cm.
Warning Possible Cause
An unsuitable pot/pan is on the induction zone
E0
or the diameter of the pot/pan is less than 12 cm.
Bad connection of the induction hob/ faulty
E1
electrical circuit.
E2 Problem with the temperature sensor.
E3 Voltage is too high.
E4 Voltage is too low.
Protection against overheating - the cooktop is
E5
too hot.
Problem with the fan, the air intake/outflow is
E6
blocked.

Setting the timer

Suitable cookware for cooking

Troubleshooting

Solution
Place suitable cookware on the cooktop.
Contact an authorized service center.
Contact an authorized service center.
Check the power source, turn on when
the power source returns to normal.
Check the power source, turn on when
the power source returns to normal.
Wait few minutes until the appliance
cools; check the pot/pan.
When the appliance cools down, clean
the openings. Afterwards, restart the
appliance. If the problem persists,
contact an authorized service center.
10