Setting And Starting A Programme - Atag VA63111LT Benutzerinformation

22
Using the detergent
A B
30
20
Setting and starting a
programme
The Auto Off function
To decrease the energy consumption, this
function automatically deactivates the appli-
ance a few minutes after:
• You have not closed the door to start the
programme.
• The programme is completed.
Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
The appliance is in setting mode when, af-
ter the activation, all the programme indica-
tors come on.
If the control panel does not show this con-
dition, press and hold, at the same time,
button and button
ance is in setting mode.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. Press the button of the programme you
want to set. The related programme in-
dicator stays on while all the other pro-
gramme indicators go off.
4. Close the appliance door, the pro-
gramme starts.
A
+ -
C
until the appli-
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appliance
door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
Starting a programme with delay
start
1. Set the programme.
2. Press
again and again until the indi-
cator of the number of hours you want
to set comes on. You can set 3, 6 or 9
hours.
• The delay start indicator comes on.
3. Close the appliance door, the count-
down starts.
• When the countdown is completed,
the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press and hold, at the same time, but-
ton and button
gramme indicators come on.
2. Set the programme again.
Cancelling the programme
1. Press and hold, at the same time, but-
ton and button
gramme indicators come on.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
until all the pro-
until all the pro-