Trouble Shooting - Springlane Mia Bedienungsanleitung

1. Remove the used stirring insert and
rinse carefully under warm water.
2. Fill the milk container with hot water
and some detergent after use. For
heavy soiling and burnt milk residue,
soak the filled container for 5­10
minutes, then
wipe with a sponge.

Trouble shooting

If the device does not work properly, please check the following steps:
1. Check if the manual was followed precisely and correctly.
2. Check the following table for possible reasons.
3. Check if all fuses are working.
problem
The operating button has
been pressed, but the sig­
nal light stays off and the
appliance does not start.
The appliance is switched
on and runs, but no milk
froth is produced.
3. The base station must not be cleaned
under running water. Use only a damp
cloth to remove dirt.
4. Do not submerge the base station.
5. The stirrer insert can be safely stowed
and protected in the storage device in
the bottom of the base station after
cleaning.
Check power cable and appliance plug. Are they cor­
rectly connected to the socket or are they damaged?
Check the general power supply to the socket.
The overheating protection is possibly blocking the
start. Did you allow the appliance to cool down suffi­
ciently after the previous use and did you observe the
prescribed capacities?
Check if a stirring insert is inserted into the milk
container.
Make sure you are using the correct stirring insert. To
produce froth, the ribbed insert must be placed into
the container.
Make sure that the stirring insert is centred and fits
snugly on the magnet holder at the bottom of the
milk container.
solution
27