Error Messages; Disposal; Returns; Information - Gemü 1434 mPos Original Einbau- Und Montageanleitung

9

Error messages

Error Error message
Set value signal
No. 1
> 20.5 mA / 10,25 V
Set value signal
No. 2
< 3.5 mA
No. 3 Positioner is not initialized
Positioner is not
No. 4
calibrated
No. 5 Device error
Warning Error message
Positioner works but at
No. 1
lower accuracy
10

Disposal

All parts must be disposed
l
of according to relevant
local or national disposal
regulations / environmental
protection laws.
Pay attention to adhered
l
residual material and gas
diffusion from penetrated
media.
11

Returns

Clean the positioner.
l
Request a goods return declaration form
l
from GEMÜ.
Returns must be made with a completed
l
declaration of return.
If not completed, GEMÜ cannot process
credits or
w
repair work
w
but will dispose of the goods at the
operator's expense.
Error cause
Set value signal
> 20.5 mA / 10.25 V
Set value signal < 3.5 mA
Positioner is not initialized
Device defect
a) Missing pneumatic
air supply
b) Leakage in
pneumatic system
Error cause
During initialisation, the
internal valves could not
be measured exactly
12
Should there be any doubts or
misunderstandings in the preceding text,
the German version of this document is the
authoritative document!
19 / 24
Error effect Error clearance
Process valve
Check the set value signal
vented
Process valve
Check the set value signal
vented
No function Start the initialisation
No function Send to GEMÜ for repair
a) Check pneumatic
Initialisation air supply
failure b) Check pneumatic
connections
Error effect Error clearance
Check for
a) Leakage of process
valve
b) Correct function of
Control is not process valve
optimized c) Unstable medium
pressure during
initialisation (if possible
turn off medium
pressure)
Note for returns:
Legal regulations for the protection
of the environment and personnel
require that the completed and
signed goods return declaration
is included with the dispatch
documents. Returned goods can
be processed only when this
declaration is completed.

Information

Note on staff training:
Please contact us at the address
on the last page for staff training
information.
1434 µPos
®