Gemü 1434 mPos Original Einbau- Und Montageanleitung Seite 12

Contents
1 Safety instructions
1.1 General information
1.2 Safety information
1.3 Correct use
1.4 Mounting position
1.5 Tools needed for installation and
assembly
1.6 Maintenance and service
2 Manufacturer's Information
2.1 Supply
2.2 Function
3 Mechanical mounting
4 Dimensions
5 Pneumatic connections
6 Electrical connections
7 Initialisation and
commissioning
7.1 Electrical and pneumatic
connection
7.2 Automatic initialisation
7.3 Commissioning
8 Display elements
9 Error messages
10 Disposal
11 Returns
12 Information
13 Technical data
14 Order data
1 Safety instructions
Please read the following safety instructions
carefully and observe them!
1.1 General information
Important requirements to ensure the perfect
function of this GEMÜ 1434 μPos
• Proper transport and storage
• Installation and commissioning by trained
staff
• Operation according to these installation,
operating and maintenance instructions
• Correct maintenance
All rights including copyright
and industrial property rights are
expressly reserved.
The GEMÜ 1434 μPos
used according to these directions.
All information in these installation,
1434 µPos
®
12
12
12
13
13
13
13
13
13
13
14
15
16
16
16
16
17
17
18
19
19
19
19
20
21
:
®
must be
®
operating and maintenance instructions
regarding operation, servicing and
maintenance must be observed and
applied. If the information is not
observed, the operator's guarantee
rights and the manufacturer's legal
liability cease.
The manufacturer shall undertake no
responsibility for the GEMÜ 1434 μPos
if these safety instructions are not
fulfilled.
Therefore, you must observe:
• the contents of these installation, operating
and maintenance instructions
• the relevant safety regulations for the
installation and operation of electrical
systems
• that this device must not be used in
explosion-endangered areas.
The regulations, norms and guidelines
named in these instructions are only
applicable in Germany. If the GEMÜ
1434 μPos is used in other countries, the
®
local regulations must be observed. When
dealing with harmonised European norms,
standards and guidelines, these apply
within the Single European Market, the
operator must also adhere to national rules if
applicable.
The descriptions and instructions in these
safety instructions refer to the standard
design.
The safety instructions do not take into
account, coincidences and events that
may occur during assembly, operation and
servicing. Local safety regulations which
must be adhered to by the operator - also
with respect to any additional assembly
personnel.
If you have any questions, please do not
hesitate to ask your closest GEMÜ sales
office.
1.2 Safety information
Only qualified and trained staff should
assemble, electrically connect and
commission the GEMÜ 1434 μPos
Use qualified staff for operation, servicing,
inspection and assembly.
The areas of responsibility should be
defined precisely and the monitoring of the
12 / 24
®
.
®