1434 Μpos; Safety Instructions; Correct Use; Mounting Position - Gemü 1434 mPos Original Einbau- Und Montageanleitung

staff and their competence carried out by the
operator. Ensure that all staff understand the

safety instructions.

Ensure the electrical safety of the host
devices.
Ensure that the electrical values are correct.
If the safety instructions are disregarded
then persons, the environment and
GEMÜ 1434 μPos
®
Furthermore, failure to observe the safety
instructions may lead to a complete loss of
claims rights.
Adhere to legal regulations!
1.3

Correct use

The GEMÜ 1434 μPos
fixed plant according to the data sheet.
In order to obtain correct product function,
the following instructions should be
observed and the information on the product
labels must also be complied with.
If these instructions and the general
installation, operating and maintenance
instructions are not observed, the guarantee
for the GEMÜ 1434 μPos
liability expires.
The GEMÜ 1434 μPos
positioner and process controller and must
be used according to the data sheet.
Any other or additional use is regarded as
contrary to regulations and GEMÜ shall not
be liable for any consequential damage. The
user carries sole risk.
Please pay attention to the pertinent
technical safety regulations when planning
both the use and operation of the device.
The designer, plant constructor or operator
is always responsible for positioning and
installation of the GEMÜ 1434 μPos
1.4

Mounting position

The mounting position of the GEMÜ
1434 μPos is optional.
®
1.5 Tools needed for installation
and assembly
The tools needed for installation and
assembly are not included in the scope of
delivery.
may be endangered.
is suitable for use in
®
and the legal
®
serves solely as a
®
.
®
1.6

Maintenance and service

If the GEMÜ 1434 μPos
used according to these installation,
operating and maintenance instructions and
the data sheet, no maintenance / service is
necessary.
To assist us in further development of this
product please forward information about
behaviour that varies from the instructions to
your nearest GEMÜ partner.
2

Manufacturer's Information

2.1

Supply

Check whether the equipment is complete
and undamaged immediately after receipt.
The items in the delivery are detailed in the
shipping documents.
Use the order numbers to check whether
the type and scope has been delivered as
ordered.
If the GEMÜ 1434 μPos
ordered as a complete unit with a valve,
these parts and the accessories belonging
to them are supplied ready assembled and
factory set.
The GEMÜ positioner is then ready for
immediate operation (reference conditions:
control pressure = 6 bar; operating pressure
= 0 bar).
2.2

Function

The GEMÜ 1434 μPos
electropneumatic positioner that can be
attached to pneumatic actuators. Normally
the GEMÜ 1434 μPos
to the actuator. The travel sensor is already
integrated in the positioner (the GEMÜ
1434 μPos can be optionally ordered
®
with an M12 cable plug for the external
attachment of the travel sensor). The travel
sensor measures the current valve position
and registers it to GEMÜ 1434 μPos
electronics. It compares the actual valve
value with the preset set value and readjusts
it if it varies too much from the standard
tolerance.
13 / 24
is installed and
®
positioner is
®
is an intelligent
®
is attached directly
®
®
1434 µPos
®