Unit Description; Description Of Use; Scope Of Delivery; Order Options - Pfannenberg DTS 6401 Serie Betriebsanleitung

ENG
3

Unit description

3.1

Description of use

The Pfannenberg add-on and built-in cooling units of the DTS and DTI series are designed for heat dissipation from switch
cabinets. Sensitive components in the switch cabinet are protected. Condensate produced during cooling is discharged through
a built-in system.
• The cooling units operate with refrigerant that is very difficult to ignite and is not harmful to the ozone layer.
3.2

Scope of delivery

The scope of delivery consists of:
• DTI/DTS cooling unit
• Brief operating instructions cooling unit
• Accessory kit: According to unit type - e.g. seal, fixing material, electrical plug connectors
• Special accessories if necessary
3.3

Order options

ATTENTION
Damage to the unit!
Damage to the unit due to spare parts from other manufacturers.
• Only original parts are subject to quality control by the manufacturer.
• Only use original manufacturer parts to ensure safe and reliable operation.
For the Pfannenberg part number for spare parts, see section "Spare parts and accessories", Page 57.
An optional extension with a filter adapter for different filter mats (felt filters, bellows filters and metal filters) is available.
For the Pfannenberg part number for accessory orders, see section "Spare parts and accessories", Page 57.
WARNING
Risk of injury due to impermissible use of the units.
Improper use of the units may lead to serious accidents.
• Only use cooling units in stationary operation.
The DTI/DTS-cooling units are only approved for stationary operation.
As cooling units of protection class IP 54, the cooling units are largely dust-protected.
Limitation: Dust can still penetrate in case of permanent exposure. The cooling units withstand splash water but not a constant
water jet.
Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 230 V | 086100005d 11/60