Cleaning And Care - Springlane Erika Bedienungsanleitung

Tips for perfect ice cream
• Homemade ice cream tastes best when
it' s fresh. It doesn't contain any preser­
vatives, which is why it should ideally be
eaten immediately.
• Make sure that you always use very
fresh eggs for your ice cream.
• For fruit flavours, always use fully ripe
fruit and add it through the lid opening
at the end of the preparation time.
• Instead of sugar, you can also use honey
or syrup as a sweetener.
• You can use cream and milk inter­
changeably as desired. The more cream
you add, the creamier your ice cream
will be.
• The colder the ice cream mixture is
before you start preparing the ice
cream, the shorter your preparation
time will be.

Cleaning and care

Erika should be cleaned and dried after
each use. Lack of or improper care of the
appliance can impair the functionality of
the ice cream maker.
• Never clean the appliance using run­
ning water or other liquids. Especially
the motor and the compressor may not
come into contact with water.
• Refrain from using scratching or
24
• Do not store the mixture in the
appliance's ice cream container. Instead,
transfer the ice cream to a suitable
container with a lid. It can be stored
in the freezer. You can prevent the
formation of ice crystals by ensuring
your container contains as little air as
possible, or by storing it upside down –
this way, the crystals will form on the
lid, not on the ice cream.
• Use up the ice cream within one week,
and never refreeze melted or thawed
ice cream.
• Only fill the ice cream container up
to 2/3 of its capacity to keep it from
spilling over. Ice cream expands during
the freezing process.
• Please note: The ice cream mixture
always tastes too sweet before freezing.
It will only taste perfect once it's frozen.
abrasive cleaning agents.
• All removable parts can be cleaned in
the dishwasher.
• Wipe off the compressor housing with a
damp cloth.
• Dry off all parts well with a soft cloth be­
fore assembling your appliance. Before
using the ice cream maker again, all parts
should be thoroughly cleaned and dry.