Door Seals; Defrosting; Replacing Of The Illuminant - Pkm KS 82.3A+ UB Bedienungsanleitung

➢ Clean with warm water and a mild, non- acidic detergent. Do not restart the
appliance until the door seals have dried completely.

5.1 Defrosting

1. The fridge is defrosted automatically. The water runs in a container near the
compressor, where it evaporates.
WARNING! Never use any mechanical items, knives or other sharp-
edged objects to remove the encrusted ice. RISK OF ELEKTRICAL
SHOCK!
1. You have to defrost the freezer manually.
2. Remove the contents and put them into a cooling box. Remove the drawers.
3. Switch off the appliance by turning the thermostat to position 0/AUS/OFF and
disconnect it from the mains.
4. When the encrusted ice melts put some dry cloths into the freezer-compartment
to hold the water back.
5. Do not support the defrosting procedure with hot water.
6. Remove the big pieces of ice first. Afterwards remove the small pieces of ice.
7. Clean and dry the appliance and door seals with soft cloths.
8. Leave the door of the appliance open for a while.

5.2 Replacing of the illuminant

1.
WARNING! Switch off the appliance and draw the plug out of the
socket. Risk of electrical shock!
2. The bulb is situated at the top of the cooling-compartment.
3. Remove the glass shelves by pulling them carefully off their guidance.
4. Remove the plastic cover of the bulb and screw out the bulb.
5. Install a new bulb (10 W / 220V-240V).
6. Fix the cover.
D
OOR SEALS
F
RIDGE
F
REEZER
49