Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C
•
Ensure that the measuring point on the
upper arm is approximately level with
your heart. If the measuring point is low-
er than the heart, the measured values
may be higher. If the measuring point is
higher than the heart, the measured values may be lower.
The results for measurements taken in a sitting and lying position
may differ slightly.
9. Selecting the user
The device is designed for two users. The values for the two users
are stored separately and can also be evaluated separately.
You may also use the two user memories to evaluate measure-
ments taken in morning and those taken in the evening separate-
ly. To do this, carry out the measurement in the morning using
user 1 and in the evening using user 2.
•
Before taking the measurement, check that the correct user
is displayed.
•
To change the user, press the user button for whose memory
bank you want to switch over to.
•
Now carry out the measurement.
Also, you will be given another opportunity to assign the meas-
urement to the correct user after the measurement has been
taken (see page 49).
EN-48
Operating the device
© Copyright Gebrauchs.info
Operating the device
10. Measuring blood pressure
•
Switch the device on using the Start/Stop
button. The following display appears (Fig-
ure 1):
•
After the device has completed its calibra-
tion against the ambient air pressure (Fig-
ure 2), the automatically controlled inflation
process starts. The cuff slowly inflates dur-
ing the measurement procedure.
•
Shortly after the inflation procedure begins,
a check is carried out to ensure that the cuff
has not been applied too loosely. If the cuff
is applied correctly, the
played. If the symbol is not displayed by the time the pulse
signal starts, the cuff is too loose. In this case, you should re-
peat the measurement after you have applied the cuff cor-
rectly (see page 46).
•
The measurement is carried out during in-
flation. The
symbol flashes in the display
(Figure 3). In addition, beeps denote the
pulse.
•
Inflation stops as soon as the measured val-
ues are determined; the cuff is then auto-
matically deflated. A long beep denotes the
end of measurement.
•
The determined systole, diastole and pulse
values, as well as the pulse pressure (PP) are
shown in the display (Figure 4).
•
When the measurement is finished, you will
be given another opportunity to change the memory to which
the measured value is to be saved. To do this, press the Mem-
C
Figure 1
Figure 2
symbol is dis-
Figure 3
Figure 4
EN-49
Werbung
Kapitel
Inhaltsverzeichnis
