Connection To The Central Module; Power Supply - G&D DVICenter DP16 Installationsanleitung

Connection to the central module

IMPORTANT:
Only connect one Transmission interface of the target module per cen-
tral module.
Use a category 5e (or better) twisted pair cable to connect the port to a
Trans. 1:
Dynamic Port of a central module. The port must be configured for the connection of
a target module.
Use a category 5e (or better) twisted pair cable to connect the port to a
Trans. 2:
Dynamic Port of another central module. The port must be configured for the connec-
tion of a target module.
NOTE:
Please also refer to the instructions in the paragraph Connecting target modules
to the central module on page 7.
ADVICE: If the network fails or a port at the central module is not working, you can
establish a direct connection between a target and a user module.
Use a category 5e (or better) crossover cable to connect the modules.

Power supply

Plug the power cable of the power pack in this interface. Then connect the
Power In:
power cable to the power pack and a power outlet.
Target modules » DVI-CPU-UC
G&D DVICenter DP16 · 36