The »U2-R-Con« User Module; Package Contents; Required Accessory; Installation - G&D DVICenter DP16 Installationsanleitung

The »U2-R-CON« user module
The U2-R-CON user module transmits USB and RS232 signals from the console to the
U2-R-CPU target module.
NOTE:
The U2-CPU target module can be connected only to the USB/RS232 Main
Channel of a stacking matrix switch.
Information about the Stacking mode is given on page 20.

Package contents

 1 × U2-R-CON user module
 1 × power pack (12V/2A)
 1 × power cable

Required accessory

One category 5e (or better) twisted pair cable to connect the target module to the
central module.

Installation

Connecting the console devices

Connect the serial end device to this interface.
RS232:
Use a category 5e (or better) twisted pair cable to connect this interface to the
Trans.:
Dynamic Port of the USB/RS232 Main Channel that is assigned to the console.
    
User modules » U2-R-CON
G&D DVICenter DP16 · 52