Showing Dynamic Port Types; User Logout - G&D DVICenter DP16 Installationsanleitung

Configuring »Dynamic Ports« « Central Module

Showing Dynamic Port types

To facilitate the installation of the KVM system, the LEDs at the Dynamic Ports can
be switched into the special port mode.
In this mode, the Dynamic Ports to connect the target or the user modules are marked
by green and yellow blinking LEDs.
1. Click on
KVM matrix systems > [Name] > DVICenter
2. Right-click the matrix switch, whose port type you want to show and click on
Dynamic Port LEDs > Show port type
3. Now the LEDs of the Dynamic Ports show the port mode:
LED
yellow
green
NOTE: The Identification LEDs on the front and back panel of the device are
blinking while the port types are shown.
4. To reset the standard port mode, right-click the matrix switch again and click on
Dynamic Port LEDs > Show status

User logout

Use the Logout button to exit the current session within the web application.
IMPORTANT: Always use the Logout function to exit your current session in order
to protect the web application against unauthorised access.
How to exit the current session within the web application:
1. Click the Logout
within the web application.
After your logout, the login box is displayed.
17 · G&D DVICenter DP16
on the context menu.
Port Type
Shows connected user modules
Shows connected target modules
on the context menu.
button (see figure on the right) to exit the current session
in the tree view.