Adjusting A Connection In The Terminal Emulation Program; Operating The Setup Menu - G&D Audio-Transceiver-CAT Installationsanleitung

Configuration

Adjusting a connection in the terminal emulation program

NOTE: In order to access the setup menu, use a terminal emulation program, which is
already installed on your computer.
If no such program is installed on your computer, you can also download the free
software PuTTY.
The following link provides a free download of this software:
http://www.chiark.greenend.org.uk/~sgtatham/putty/
How to adjust the connection in the terminal emulation program:
1. Start any terminal emulation program (HyperTerminal or PuTTY, for example).
2. Create a new connection in the terminal emulation program and enter the fol-
lowing connection settings:
Bits per second:
Data bits:
Parity:
Stop bits:
Flow control:
3. Connect the Service interface of the signal extender's transmitter or receiver to one
of the computer's USB interfaces. Use the supplied service cable for this purpose.

Operating the setup menu

The setup menu lists all signal extender settings in tabular form:
Setup Menu for Audio-Transceiver
Show Firmware Info
Set System Defaults
Input:
SPDIF Output:
Show SPDIF Parameters:
'Space': Toggle
The current setting of the different functions is displayed in the right column. The
three dots in the right column indicate that this particular function provides a sub
dialogue.
7 · Audio-Transceiver-CAT
115.200
8
none
1
none
...
...
Auto
96 kHz
...
'S': Save