Power Supply - G&D DVICenter DP16 Installationsanleitung

DVI-CPU « Target modules

Power supply

Power In: Plug the power cable of the power pack in this interface. Then connect the
power cable to the power pack and a power outlet.
NOTE: If a power pack connected to the Power In interface provides power to a tar-
get module, up to two other target modules can use this power source via Power
Loop cables.
1. Connect the power pack  to the first target module.
2. Plug a »Power Loop« cable  in the Power Loop interface of the first target mod-
ule. Connect the other end to the Power In interface of the second target module.
3. If required, connect another »Power Loop« cable  to the Power Loop interface of
the second target module. Connect the other end to the Power In interface of the
third target module.
Trans. Line In Line Out
Service
31 · G&D DVICenter DP16
Trans. Service Line In Line Out

Power Loop Power In
Trans. Service Line In Line Out

Power Loop Power In
Power Loop Pow er In
