Adjusting The Bus Address Of Matrix Switches - G&D DVICenter DP16 Installationsanleitung

Expanding switchable signals « Central module
How to connect a stack matrix switch:
1. Use a category 5e (or better) twisted pair cable to connect the
the new satellite matrix switch to the
mary matrix switch.
NOTE: The primary and the last stack matrix switch may be placed up to 100
metres apart.
2. Check and change the bus address of the stack matrix switch, if required (see
page 25).

Adjusting the bus address of matrix switches

The primary matrix switch automatically makes the stack matrix switches access the
same port that the user accesses at the primary matrix switch.
This requires the correct setting of the bus address in the individual matrix switches.
How to change the bus address of a matrix switch:
1. Press Ctrl (default) to open the on-screen display.
2. Press F11 to call the Configuration menu.
3. Choose System
4. Choose
Bus address
primary:
satellite 1 ... 9:
5. Press to save your settings.
F2
25 · G&D DVICenter DP16
and press Enter .
and press to select one of the following options:
F8
The central module is operated by the user.
It switches the satellite matrix switches automatically.
Assign the addresses continuously to the individual stacking
matrix switches.
Bus Out interface of the "last" satellite or pri-
Bus In interface of