Voltage; Electrical Connectors - J+J J4C S Serie Kurzanleitung

ENGLISH - J4C 20 TO 300 INSTALLATION INSTRUCTIONS
READ THESE INSTRUCTIONS BEFORE CONNECTING THE ACTUATOR. DAMAGE CAUSED BY NON
COMPLIANCE OF THESE INSTRUCTIONS IS NOT COVERED BY OUR WARRANTY.
J4C Electric actuators operate with the use of live electricity. It is recommended that only qualified
electrical engineers be allowed to connect or adjust these actuators.

1. VOLTAGE

·
All our actuators model S20 to S300 are ready to work from 24-240 VAC and 24-135 VDC
·
All our actuators model H20 to H300 are ready to work from 85-240 VAC/VDC
·
All our actuators model B20 to B300 are ready to work at 12 VDC/VAC ONLY

2. ELECTRICAL CONNECTORS

Warning: Before connecting ensure that the voltage to be applied to the actuator is within the range
shown on the identification label. The supplied electrical connectors, used to connect to the actuator
are DIN plugs. Ensure the diameter of cable to be used conforms to the maximum and minimum
requirements of the DIN plugs to maintain water tightness (Fig.1).
Warning: Ensure that the square rubber seal is in place when fixing each DIN plug to the actuator.
Failure to do so could allow water ingress and damage caused by this installation error will invalidate
any warranty. The DIN plugs are fixed to their respective bases on the actuator housing with a screw.
Do not over tight the screw (8) when assembling (Max. 0.5Nm).
1. Gasket
2. Terminal strip
3. Cable fixing screws
4. Housing
5. Washer
INDEX
6. Grommet
7. Gland - nut
8. Fixing screw
9. Washer
10. Gasket
(Fig.1)
(Fig.2)
02