Installation Instructions; Before Installation; After Installation - Pando PHM-950 Handbuch

INOXPAN S.L. EN - 31

15. INSTALLATION INSTRUCTIONS

BEFORE INSTALLATION

Check that the input voltage indicated on the characteristics plate is the same as the voltage of
the power outlet you are going to use.
Open the oven door and take out all the accessories and remove the packing material.
Warning! The front surface of the oven may be wrapped with a protective film. Before using the
oven for the first time, carefully remove this film, starting on the inside.
Make sure that the oven is not damaged in any way. Check that the oven door closes correctly
and that the interior of the door and the front of the oven opening are not damaged. If you find any
damage contact the Technical Assistance Service.
DO NOT USE THE OVEN if the power cable or the plug are damaged, if the oven does not function
correctly or if it has been damaged or dropped. Contact the Technical Assistance Service.
Put the oven on a flat and stable surface. The oven must not be put close to any sources of heat,
radios or televisions.
During installation, make sure that the power cable does not come into contact with any
moisture or objects with sharp edges behind the oven. High temperatures can damage the
cable.
Warning: after the oven is installed you must make sure you can access the plug.

AFTER INSTALLATION

The oven is equipped with a power cable and a plug for single phase current.
If the oven is to be installed on a permanent basis it should be installed by a qualified technician.
In such a case, the oven should be connected to a circuit with an all-pole circuit breaker with a
minimum separation of 3 mm between contacts.
WARNING: THE OVEN MUST BE EARTHED.
The manufacturer and retailers do not accept responsibility for any damage that may be caused
to people, animals or property if these installation instructions are not observed.
The oven only functions when the door is closed correctly.
Before the first use, clean the inside of the oven and the accessories, following the cleaning
instructions given in the section "Oven cleaning and maintenance".