When The Oven Is Working; Interrupting A Cooking Cycle; Altering Parameters; Cancelling A Cooking Cycle - Pando PHM-950 Handbuch

INOXPAN S.L.

7. WHEN THE OVEN IS WORKING...

7.1. INTERRUPTING A COOKING CYCLE

You can stop the cooking process at any time by pressing the Function Selector knob (1) once or
by opening the oven door.
In both cases:
 Microwave emission is stopped immediately.
 The grill is de-activated but is still very hot. Danger of burning!
 The timer stops and the display shows the remaining amount of operating time.
If you wish, at this time you can:
1. Turn or stir the food to ensure it will be evenly cooked.
2. Change the process parameters.
3. Cancel the process by pressing the function selector knob (1) for 3 seconds.
To restart the process, close the door and press the Function Selector knob (1).

7.2. ALTERING PARAMETERS

The operating parameters (time, weight, power, etc.) can be altered when the cooking process has
been interrupted by proceeding as follows:
1. To alter the time, turn the rotating knob (3) and confirm by pressing the function selector knob (1).
The new time defined is immediately valid.
2. To alter the power, press the function selector knob (1). The respective light start to flash. Alter
the parameter by pressing the rotating knob (3) and then turn the rotating knob (3), confirm by
pressing the function selector knob (1) again.

7.3. CANCELLING A COOKING CYCLE

If you wish to cancel the cooking process, press the function selector knob (1) for 3 seconds.
You will then hear a beep and the time will appear on the display.

7.4. END OF A COOKING CYCLE

At the end of the process you will hear three beeps and the display will show the word "End".
The beeps are repeated every 30 seconds until the door is opened or the function selector knob (1)
is pressed.
EN - 18