Troubleshooting Guide; Customer Service Department; Warranty; Accessories And Spare Parts - Kärcher NT 50/2 Me Classic Betriebsanleitung

Troubleshooting guide

DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
Suction turbine does not start up
1. Check the socket and the power supply fuse.
2. Check the mains cable, mains plug and float on the
device.
3. Switch on the device.
Suction turbine runs, but the device does not suck
1. Switch off the device and wait for 5 seconds. Switch
on the device.
2. Release the jammed float and clean it with a damp
cloth. Check float for freedom of movement.
Float closes suction duct
1. Empty the dirt receptacle.
Suction power decreases
1. Remove any blockages from the suction nozzle,
suction pipe, suction hose or cartridge filter.
2. NT 50/2 only: Change the filled fleece filter bag
(special accessory).
3. Clean the membrane filter (special accessory) un-
der running water or change.
4. Change the cartridge filter.
5. Only NT 70/2, NT 90/2: Check the drain hose for
leaks.
Escaping dust when vacuuming
1. Check that the cartridge filter is correctly fitted.
2. Change the cartridge filter.
Water leaking when vacuuming
1. Release the jammed float and clean it with a damp
cloth. Check float for freedom of movement.

Customer Service department

If the malfunction cannot be corrected, the device must
be checked by the Customer Service department.

Warranty

The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)

Accessories and spare parts

Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.

EU Declaration of Conformity

We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements in the EU Directives, both in its basic design
and construction as well as in the version placed in cir-
culation by us. This declaration is invalidated by any
changes made to the machine that are not approved by
us.
Product: Wet/dry vacuum cleaner
Type: 1.667-xxx
Currently applicable EU Directives
2006/42/EC (+2009/127/EC)
2011/65/EU
2014/30/EU
Harmonised standards used
EN IEC 63000: 2018
EN 55014-1: 2017 + A11: 2020
EN 55014-2: 2015
EN 60335-1
EN 60335-2-69
EN 61000-3-2: 2014
EN 61000-3-3: 2013
EN 62233: 2008
National standards used
-
The undersigned act on behalf and under the power of
attorney of the company management.
H. Jenner
Chairman of the Board of Management
Documentation supervisor:
S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2020/10/01
English
S. Reiser
Director Regulatory Affairs & Certification
11