Required Tools; Disassembling - Bosch Rexroth 2GE Serie Montageanleitung

64/70 Bosch Rexroth AG
Disassembly and replacement
CAUTION
Hot surfaces possible, particularly
on motor housings and gearboxes!
Risk of injury! Risk of burns!

Do not touch device housing sur-
faces at heat sources! Risk of burns!

Do not touch housing surfaces of
motors and gearboxes! Risk of burns!

Depending on the operating condi-
tions, temperatures during or after
operation may exceed 60 °C
(140 °F).

After switching off the motors, allow
them to cool down sufficiently before
accessing them.

Wear protective gloves or do not
work near hot surfaces.
This section describes the disassembly and
the replacement of a planetary gearbox.

11.1 Required tools

• Bench vise with braces
• Hook wrench with joint DIN 1810 form B
(torque wrench of the company Saltus)
– Design 0 608 PE0 384
(diameter 60...90 mm)
– Design 0 608 PE0 385
(diameter 35...60 mm)
• Fork wrench DIN 894 or DIN 895
• Hook wrench
• Fork wrench
2/3/4/5GE.... | 3 608 870 E96/2016-03

11.2 Disassembling

NOTE
Incorrect assembly/disassembly of
planetary gearbox possible!
Material damage and malfunction of the
planetary gearbox in later operation.

During assembly/disassembly, it is
imperative that you hold the planetary
gearbox horizontally. Otherwise,
there is the risk of the gears and nee-
dle bearings loosening from the gear-
box.
NOTE
Incorrect motor assembly/disas-
sembly possible!
Material damage to the motor due to in-
correct clamping into a bench vise.

Clamp the motor only slightly and
use extensive braces.