Required Tools; Assembling The Product - Bosch Rexroth 2GE Serie Montageanleitung

2/3/4/5GE.... | 3 608 870 E96/2016-03
CAUTION
Hot surfaces possible, particularly
on motor housings and gearboxes!
Risk of injury! Risk of burns!

Do not touch device housing sur-
faces at heat sources! Risk of burns!

Do not touch housing surfaces of
motors and gearboxes! Risk of burns!

Depending on the operating condi-
tions, temperatures during or after
operation may exceed 60 °C
(140 °F).

After switching off the motors, allow
them to cool down sufficiently before
accessing them.

Wear protective gloves or do not
work near hot surfaces.
NOTE
Insufficient heat dissipation!
The heat resulting in the tightening pro-
cess, caused by the waste heat of the
EC motor may restrict the functionality of
the tightening spindle and its compo-
nents and lead to material damage.

Provide for sufficient heat dissipa-
tion by assembling the tightening
spindle onto metallic carrier plates.
This section describes the assembly of a
planetary gearbox.
Bosch Rexroth AG
6.1

Required tools

• Bench vise with braces
• Hook wrench with joint DIN 1810 form B
(torque wrench of the company Saltus)
– Design 0 608 PE0 384
(diameter 60...90 mm)
– Design 0 608 PE0 385
(diameter 35...60 mm)
• Fork wrench DIN 894 or DIN 895
• Hook wrench
• Fork wrench
6.2

Assembling the product

If a tightening spindle is installed
horizontally, an additional support
for the tightening spindle, e.g. near
the gearbox, is recommended.
NOTE
Incorrect assembly of planetary ge-
arbox possible!
Material damage and malfunction of the
planetary gearbox in later operation.

During assembly/disassembly, it is
imperative that you hold the planetary
gearbox horizontally. Otherwise,
there is the risk of the gears and nee-
dle bearings loosening from the gear-
box.

It is imperative that you install the
start-up step that is located on the
motor side under the protective cap.

Only use the planetary gearbox to-
gether with Rexroth components.
55/70
Assembly