Safety Instructions; About This Chapter; Intended Use; Improper Use - Bosch Rexroth 2GE Serie Montageanleitung

2/3/4/5GE.... | 3 608 870 E96/2016-03
2

Safety Instructions

This chapter describes the general safety
requirements and important information on
the safe assembly of the product.
2.1

About this chapter

The product has been manufactured ac-
cording to the accepted rules of current
technology. There is, however, still a danger
of personal injury or damage to equipment if
this chapter and the safety instructions in
this documentation are not complied with.

Read this documentation completely
and thoroughly before working with the
product.

Keep this documentation in a location
where it is accessible to all users at all
times.

Always include the required documen-
tation when you pass the product on to
third parties.
2.2

Intended use

The product described in this documenta-
tion is exclusively intended for installation in
Rexroth tightening spindles in connection
with control and power electronics for Rex-
roth tightening systems and the related con-
necting cables.
The product is intended for industrial use
and not for private use.
Observe the operating conditions and per-
formance limits specified in the technical
data.
Intended use includes having read and un-
derstood this documentation and especially
the chapter "Safety instructions".
Bosch Rexroth AG
2.3

Improper use

Any other use
• than that described in the intended use
and
• than that described in the respective doc-
umentation
is regarded as unintended use and is there-
fore inadmissible.
Bosch Rexroth AG will not accept any liabil-
ity for damage caused by the unintended
use. The risks in case of unintended use are
exclusively borne by the user.
The unintended use of the product and its
components (if available) includes:
• that it is subjected to operating condi-
tions that do not fulfill the specified ambi-
ent conditions. Operation is forbidden
e.g. under water, with extreme air humid-
ity, under extreme temperature fluctua-
tions, or under extreme maximum temper-
atures.
• that it is used in applications that have not
been explicitly approved by
Bosch Rexroth AG. Always observe the
safety instructions in the respective doc-
umentation.
• the structural change destroying the orig-
inal state.
• the improper programming or configura-
tion of the tightening system.
The user is solely responsible for risks
caused by programming and configura-
tion of the tightening system.
45/70
Safety Instructions