Bosch Rexroth 2GE Serie Montageanleitung Seite 48

48/70 Bosch Rexroth AG
Safety Instructions
DANGER
High voltage!
Danger to life, risk of injury due to electric shock, or risk of serious injury!

Before using the system or starting service/maintenance work, make sure you read
and understand these operating instructions.

This device may only be operated, maintained and/or repaired by personnel trained
and qualified to work on or with electrical devices.

Observe the general construction and safety regulations for working with high-voltage
systems.

Firmly connect the protective conductor to all electrical devices according to the con-
nection diagram before switching the system on.

Operation, even briefly for measuring or testing purposes, is only permitted if the pro-
tective conductor is firmly connected to the components at the intended points.

Disconnect the device from the mains or voltage source before accessing electrical
parts with voltages greater than 50 V. Protect it against accidential switch-on.

After switching off the power supply, wait 10 seconds for the system to discharge be-
fore opening the housing or starting repair/maintenance work.

For electrical drive and filter components:
After switching off, take the specified discharging time for the respective components
into account before accessing the devices. To eliminate the risk of contact, measure
the voltage of the condensers before starting work.

Do not touch the electrical connection points of the components when the device is
switched on.
European countries: Corresponding to EN 50178/1998, paragraph 5.3.2.3.
USA: See National Electrical Code (NEC), National Electrical Manufacturers Association
(NEMA), as well as regional building codes.
The operator must comply with all of the above listed at all times.
2/3/4/5GE.... | 3 608 870 E96/2016-03