Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Remove the battery pack.
2. Remove the plant residue using a brush.
3. Clean the device with a moist cloth.
Removing the second handle
Illustration R
The second handle can be removed for repair purposes.
1. Release the lock on the second handle with a flat-
blade screwdriver.
2. Pull the second handle downwards and out of the
holder.
Take care to ensure that the second handle engages on
re-installation.
Troubleshooting guide
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
As the battery pack ages, even if it is looked after, its ca-
pacity reduces such that the full run time will no longer
be reached when fully charged. This does not indicate a
defect.
The device does not start up
The battery pack is not inserted correctly.
1. Push the battery pack into the mounting in the de-
vice until it audibly latches into place.
The battery pack is discharged.
1. Charge the battery pack.
The battery pack is in sleep mode.
1. Press and hold the power switch longer or press the
power switch a second time.
The battery pack is defective.
1. Replace the battery pack.
Bristle strip blocked/device overloaded/motor protection
has triggered.
1. Allow the device to cool down for a few minutes.
2. Press less hard when operating the device
The device stops during operation
The battery has overheated
Stop working and allow the battery to cool down to
the permissible temperature range. This can take a
few minutes.
Unsatisfactory cleaning results
Worn bristles
Replace the bristle strip.
Bristle strip locking cover including guide aid can-
not be opened
Soiling
1. Remove the battery pack.
2. Insert a flat screwdriver into the guide aid recess.
Illustration S
3. Using the screwdriver as a lever, turn the brush pro-
tective cover in the direction of the "lock open" sym-
bol.
Warranty
The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
Technical data
Device performance data
Battery pack type
Working voltage of the bat-
tery
Brush speed
Brush diameter
Brush material
Dimensions and weights
Weight
Length x width x height
Determined values
Hand-arm vibration value m/s
Uncertainty K
Sound pressure level
Uncertainty K
pA
Sound power level L
K uncertainty
WA
Subject to technical modifications.
EU Declaration of Conformity
We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements in the EU Directives, both in its basic design
and construction as well as in the version placed in cir-
culation by us. This declaration is invalidated by any
changes made to the machine that are not approved by
us.
Product: Weed remover
Type: WRE18-55 Battery
Currently applicable EU Directives
2006/42/EC (+2009/127/EC)
2014/30/EU
2011/65/EU
2000/14/EC
Harmonised standards used
EN 60335-1
EN 62233: 2008
EN 55014-1: 2006+A2: 2011
EN 55014-2
EN 50581
Conformity evaluation procedure used
2000/14/EC: Annex V
Sound power level dB(A)
Measured: 83
Guaranteed: 87
The undersigned act on behalf and under the power of
attorney of the company management.
English
WRE 18
-55
-
V
18
1/min 2300-
2800
mm
180
Nylon
kg
2,8
mm
1370 x 2
30 x 380
2
3,2
2
m/s
0,5
dB(A) 71
dB(A) 2
+
dB(A) 87
WA
WRE 18
-
55 Batte
ry Set
Battery
Power
18/25
18
2300-
2800
180
Nylon
3,3
1370 x 2
30 x 380
3,2
0,5
71
2
87
13
Werbung
Kapitel
Fehlerbehebung
