Quiet Mode - RHOSS H58624/B Gebrauchsanweisung

2.2.5 Quiet Mode

At the Function setting page, by touching "Quiet mode", there will be a choice box, where "Quiet mode" can be set to "On", "Off", or "Timer".
When it is set to "Timer", it is also required to set the "Start timer" and "End timer" (these values remain in memory).
Then, by touching the "Save" icon, the settings will be saved.
NOTE

Silent mode can be set while the main unit is turned on or off but only takes effect when the main unit is turned on.

When Quiet mode is set to "On", it will automatically back to "Off" if the main unit is turned off manually;
when Quiet mode is set to "Timer", this setting will remain unless the main unit is turned off by End timer or the main unit is turned off
manually.

The setting is memorized and re-proposed in case of power failure (see 2.6.1 On/Off memory).

The default value is Off.
2.2.6 Weather Depend (set point compensation)
At the Function setting page, by touching "Weather depend", there will be a choice box, where it is able to set it
is able to set the weather-dependent temperature.
This function modifies automatically the set point (water supply or ambient air, see 2.5.1 Control temperature) according to the external temperature.
NOTE

When "Weather depend" has been activated, it cannot be deactivated by ON/OFF unit but only done manually choosing "Weather
depend: Off".

It is possible to read the target temperature in the Visual (Display) pages (see 2.4.2 Parameter, T climatic curve).

When this function has been activated, it is still allowed to set the room temperature, however, this setting becomes valid only when
"Weather depend" has been deactivated.

This function can be set to "On" no matter the unit is turned on or off, but it works only when the unit is turned on.

This function only works for "Cool" and "Heat" mode. Under the "Hot water" mode, it cannot be activated.

This function can be applied to the supply water temperature or to the ambient air temperature (in this last case it is necessary to connect
the remote air probe delivered together with the unit), (see 2.5.1 Control temperature).

The setting is memorized and re-proposed in case of power failure (see 2.6.1 On/Off memory).

The default value is Off.
< Save
Scroll up
Scroll down
Regulation on water supply:
A Upper WT-Cool/Heat
B Lower WT-Cool/Heat
C Lower AT-Cool/Heat
D Upper AT-Cool/Heat
Regulation on room temperature:
A Upper RT-Cool/Heat
B Lower RT-Cool/Heat
C Lower AT-Cool/Heat
D Upper AT-Cool/Heat
39
ELECTA-ECO
to "On" or "Off", and also it