Calling Up The Temperature Display; Deinstallation; Disconnecting The Lines - Steinbach Poll Professional heatUP 650 Originalbetriebsanleitung

Calling up the temperature display

1. Put the heat pump into any operating mode (see "Display" section).
2. Press and hold the Clock button
The temperature of a temperature sensor appears on the display.
3. Press the Clock button
You can switch between the different temperature sensors by pressing the Clock
button again (see "Display" section). If there is not input for more than 10
13
seconds, the temperature display disappears from the display.
4. Press the ON/OFF button
The temperature display disappears. The display shows the regular operating mode
content.

Deinstallation

Disconnecting the lines

Disconnecting the power supply (heatUP 650 and 900)
1. Switch the heat pump to standby mode (see section "Display").
2. Disconnect the mains plug
All the display elements on the display
power supply and is not in operation.
Disconnecting the power supply (heatUP 1100 and 1400)
1. Switch the heat pump to standby mode (see section "Display").
2. Carefully disconnect the power cable
All the display elements on the display
power supply and is not in operation.
Disconnecting the water pipes
1. Deactivate the water treatment pump.
2. Fully loosen the union nut
3. Pull the feed pipe off of the water connection input
When removing the hose, hold it with the opening pointing up so that any remaining
water in the hose does not suddenly escape.
4. Fully loosen the union nut
5. Pull the drain hose off of the water connection output
When removing the hose, hold it with the opening pointing up so that any remaining
water in the hose does not suddenly escape.
66
for about 3 seconds.
13
.
13
.
18
of the supply line from the power supply.
9
go out. The heat pump is disconnected from the
C
of the supply line from the power supply.
9
go out. The heat pump is disconnected from the
C
at the water connection input
2
at the water connection output
2
.
8
.
8
.
6
.
6