Specifications; Ec Declaration Of Conformity; Specific Safety Rules - Makita HM1304B Bedienungsanleitung

ENGLISH
1-1. Lock button
1-2. Switch trigger
2-1. Side handle
2-2. Nut
2-3. Projecting portion of side handle
2-4. Notch on set bolt
2-5. Set bolt

SPECIFICATIONS

Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for heavy chiselling and demolition
work as well as for driving and compacting with
appropriate accessories.
Power supply
The tool should be connected only to a power supply of the
same voltage as indicated on the nameplate, and can only be
operated on single-phase
double-insulated in accordance with European Standard and
can, therefore, also be used from sockets without earth wire.
Model; HM1304B
For European countries only
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
Measured sound power level: 100 dB
Guaranteed sound power level: 103 dB
These sound power
accordance with Council Directive, 2000/14/EC.
Conformity assessment procedure: Annex VI
Notified body: BSI Product Services, Maylands Avenue,
Hemel Hempstead HP2 4SQ, England
Vibration
The typical weighted root mean square acceleration
2
value is 13 m/s .
This value has been obtained according to EN60745.
Yasuhiko Kanzaki CE2006
000087
Explanation of general view
3-1. Bit with collar
3-2. Bit without collar
4-1. Commutator
4-2. Insulating tip
4-3. Carbon brush
5-1. Holder cap plate
5-2. Screwdriver
Model
Overall length
Net weight
Safety class
AC supply. They
levels were measured
ENE046-1
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
ENF002-1
Makita Corporation Anjo Aichi Japan

SPECIFIC SAFETY RULES

are
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to hammer safety rules. If you use this tool unsafely
ENH112-6
or incorrectly, you can suffer serious personal
injury.
1. Wear ear protectors. Exposure to noise can
cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tools by insulated gripping
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
in
the operator.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun
glasses are NOT safety glasses. It is also
highly recommended that you wear a dust
mask and thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
6. Under normal operation, the tool is designed
to produce vibration. The screws can come
loose easily, causing a breakdown or accident.
Check tightness of screws carefully before
operation.
7. In cold weather or when the tool has not been
3
6-1. Brush holder cap
6-2. Screwdriver
7-1. Hex wrench
7-2. Crank cap
8-1. Hammer grease
HM1304B
-1
1450 min
831 mm
17 kg
/II
Director
GEB004-2